LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1674 (Wiper System & Washer System) >> Removal And Installation >> Wiper Motor - Windshield >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wiper mounting arm and pivot shaft assembly. For additional information, refer to WIPER MOUNTING ARM AND PIVOT SHAFT .
  2. Remove the windshield motor.
    1. Disconnect the wiper pivot arm linkage.
    2. Remove the 3 bolts.
    • To install, tighten to 18 Nm (13 lb-ft).
    Fig 1: Identifying Windshield Wiper Motor Components
    G04659127Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals