LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1674 (Wiper System & Washer System) >> Removal And Installation >> Wiper Motor - Rear Window >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear wiper pivot arm. For additional information, refer to WIPER PIVOT ARM - REAR .
  2. Remove the liftgate trim panel. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Open the rear window wiper pivot arm nut cover.
    Fig 1: Opening Rear Window Wiper Pivot Arm Nut Cover
    G04659129Courtesy of FORD MOTOR CO.
  4. Remove the rear window wiper pivot arm nut.
    • To install, tighten to 15 N.m (11 lb-ft).
    Fig 2: Removing Rear Window Wiper Pivot Arm Nut
    G04659130Courtesy of FORD MOTOR CO.
  5. Remove the rear window wiper assembly.
    • Disconnect the electrical connector.
    • Remove the 3 bolts.
    • To install, tighten to 8 N.m (71 lb-in).
    Fig 3: Removing Rear Window Wiper Assembly
    G04659131Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals