LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1670 (Electronic Engine Control System) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Remove the 7 pin-type retainers and the RH splash shield.
  4. Disconnect the crankshaft position (CKP) sensor electrical connector.
  5. Remove the bolt and the CKP sensor.
    • To install, tighten to 10 N.m (89 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals