LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1669 (Exterior Lighting System) >> Diagnosis And Testing >> Daytime Running Lamps (DRL) >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When installing a new smart junction box (SJB), it must be reconfigured for this feature, if originally equipped. Refer to PROGRAMMABLE MODULE INSTALLATION .
  1. Verify the customer concern by operating the daytime running lamps (DRL) following these steps:
    • Place the ignition switch in the RUN position.
    • Place the headlamp switch in the OFF position.
    • If the DRL does not operate, make sure the SJB is configured for DRL before proceeding to the next step.
  2. Verify the parking lamp operation.
    • Place the headlamp switch in the PARKING LAMPS ON position.

    If the parking lamps do not operate correctly, refer to PARKING, REAR AND LICENSE PLATE LAMPS .

  3. Verify the low beam operation.
    • Place the headlamp switch in the HEADLAMPS ON position.
    • Place the multifunction switch in the LOW BEAM position.

    If the low beams operate correctly and the DRL operation is incorrect, install a new SJB. Refer to REMOVAL AND INSTALLATION . Test the system for normal operation.

    If the low beams do not operate correctly, refer to HEADLAMPS .

scientia non olet · About LEMON Manuals