LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1661 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Remote Keyless Entry Keypad >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Position the watershield aside.
  3. Disconnect the remote keyless entry (RKE) keypad electrical connector.
  4. Release the RKE keypad harness from the door panel
  5. Position the front door glass top run aside.
  6. Remove the RKE keypad.
    • Through the access hole in the front door pillar, release the RKE keypad retainer.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals