LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1660 (Anti-Lock Brake System) >> Removal And Installation >> Wheel Speed Sensor - Rear, Front Wheel Drive (FWD) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the wheel speed sensor electrical connector.
  3. Remove the 2 wheel speed sensor harness retainers.
  4. Remove the wheel speed sensor bolt.
    • To install, tighten to 8 N.m (71 lb-in).
  5. Remove the wheel speed sensor.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals