On-Board Diagnostic (OBD) With Diagnostic Tool
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For detailed instruction and other diagnostic methods using the diagnostic tool or equivalent, refer to the diagnostic tool tester manual and the INTRODUCTION - GASOLINE
article.
These Quick Tests should be used to diagnose the powertrain control module (PCM) and should be carried out in order.
- Quick Test 1.0 - Visual Inspection
- Quick Test 2.0 - Set Up
- Quick Test 3.0 - Key On, Engine Off (KOEO)
- Quick Test 4.0 - Continuous Memory Codes
- Quick Test 5.0 (KOER) - Key On, Engine Running
- Special Test Modes
- Wiggle Test Mode
- Output Test Mode
- PCM Reset Mode
- Clearing DTCs P1000
- On-Board Diagnostic (OBD) II Drive Cycle
- Other Diagnostic Tool Features
For other diagnostic testing features using the diagnostic tool, refer to INTRODUCTION - GASOLINE article. Other diagnostic methods include the following:
- Parameter Identification (PID) Access Mode
- Freeze Frame Data Access Mode
- Oxygen Sensor Monitor Mode