LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1653 (Transfer Case - Power Transfer Unit (PTU)) >> Removal >> Input Shaft Seal

Input Shaft Seal

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power transfer unit (PTU). For additional information, refer to POWER TRANSFER UNIT (PTU)  .
  2. Remove the input shaft oil slinger.
    Fig 1: Removing Input Shaft Oil Slinger
    G04657658Courtesy of FORD MOTOR CO.
  3. Remove and discard the input shaft seal.
    Fig 2: Removing Input Shaft Seal
    G04657659Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals