LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1652 (Driveline System - General Information) >> Diagnosis And Testing >> Driveline System >> Inspection and Verification >> Preliminary Diagnosis >> Wheel Hub Face Runout

Wheel Hub Face Runout

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the special tool on the wheel hub face, as close to the outer edge as possible. Zero the indicator to allow the pointer to deflect either way.
    Fig 1: Measuring Wheel Hub Face Runout
    G04655363Courtesy of FORD MOTOR CO.
  2. Rotate the hub one full turn and note the maximum and minimum readings. The difference between the maximum and minimum readings will be the total face runout. The runout must not exceed 0.254 mm (0.010 inch).
scientia non olet · About LEMON Manuals