Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
- Remove the lower intake manifold. For additional information, refer to REMOVAL .
- Disconnect the fuel rail pressure and temperature sensor electrical connector.
- Disconnect the 6 fuel injector electrical connectors.
- Detach the fuel charging wiring harness from the lower intake manifold assembly.
- To install, reverse the removal procedure.