LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1643 (Automatic Transaxle - 6 Speed) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnosis by Symptom Table Directions

Diagnosis by Symptom Table Directions

WARNING: This page is about a different car, the 2006 Mercury Montego and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Symptom Index, select the concern/symptom that best describes the condition.
  2. See the routine indicated in the diagnosis by Symptom Index.
  3. Always begin diagnosis of a symptom with:
    • Preliminary inspections.
    • Verifications of condition.
    • Checking the fluid levels.
    • Carry out other test procedures as directed.
  4. NOTE: Not all concerns and conditions with electrical components will set a diagnostic trouble code (DTC). Be aware that the components listed may still be the cause. Verify correct function of these components prior to proceeding to the routine listed.
  5. Begin with the routine indicated. Follow the reference or action required statements. Always carry out the on-board diagnostic tests as required. Never skip steps. Repair as required. These components are listed in the removal sequence and by the most probable cause. All components listed must be inspected to make sure of correct repair.

    Diagnosis by Symptom Index 

    SYMPTOM TABLE

    Title Routine
    Other Concerns  -
    Transmission fluid level 286
    Transmission fluid condition 287
    Transmission control module software 288
    Engagement Concerns  -
    No forward and/or no reverse 207
    Harsh 208
    Soft 209
    Torque Converter Clutch Operation Concerns   
    Does not apply 240
    Cycling/shudder/chatters 242