LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Starting System) >> General Procedures >> Starter Motor Drive Gear and Flywheel Ring Gear Inspection

Starter Motor Drive Gear and Flywheel Ring Gear Inspection

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the starter motor. For additional information, refer to STARTER MOTOR - CVT  or STARTER MOTOR - 6 SPEED .
  2. Check the wear patterns on the starter drive gear and the flywheel ring gear. If the wear pattern is normal, install the starter motor. For additional information, refer to STARTER MOTOR - CVT  or STARTER MOTOR - 6 SPEED .
    Fig 1: Identifying Starter Drive Gear & Flywheel Ring Gear (1 Of 2)
    G04656153Courtesy of FORD MOTOR CO.
  3. If the starter drive gear and the flywheel ring gear are not fully meshing and both of the gears are scored or damaged, install a new starter motor. For additional information, refer to STARTER MOTOR - CVT  or STARTER MOTOR - 6 SPEED .

    If necessary, install a new flywheel. For additional information, refer to ENGINE .

    Fig 2: Identifying Starter Drive Gear & Flywheel Ring Gear (2 Of 2)
    G04656154Courtesy of FORD MOTOR CO.