Inspection and Verification
WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
- Road test.
- Verify the customer's concern by carrying out a road test on a smooth road.
- Inspect tires.
- Check the tire pressure with all normal loads in the vehicle and the tires cold. For additional information, refer to the VEHICLE CERTIFICATION (VC) LABEL .
- Verify that all tires are sized to specification.
- Inspect the tires for incorrect wear and damage.
- Inspect the chassis and underbody.
- Remove any excessive accumulation of mud, dirt or road deposits from the chassis and underbody.
- Inspect for aftermarket equipment.
- Check for aftermarket changes to the steering, suspension wheel and tire components (such as competition or heavy duty) The specifications shown in this article do not apply to vehicles equipped with aftermarket equipment.
VISUAL INSPECTION TABLEMechanical - Front wheel bearing(s)
- Loose or damaged front or rear suspension components
- Loose, damaged or missing suspension fastener(s)
- Damaged or leaking strut(s)
- Worn or damaged suspension bushing(s)
- Loose, worn or damaged steering system components
- Damaged axle components
- If an obvious cause for an observed or reported condition is found, correct the cause (if possible) before proceeding to the next step.
- If the fault is not visually evident, determine the symptom. GO to SYMPTOM TABLE .