LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1628 (Rear Disc Brake System) >> Removal And Installation >> Rear Disc Brake >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to REMOVAL .
    2. CAUTION: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
  2. Remove the brake caliper anchor plate bolts and discard. Position the brake caliper anchor plate aside.
    • To install, tighten to 110 N.m (81 lb-ft).
  3. Remove and discard the brake disc screw.
    • To install, tighten to 21 N.m (15 lb-ft).
  4. Remove the brake disc.
  5. To install, reverse the removal procedure, using 2 new brake caliper anchor plate bolts.
scientia non olet · About LEMON Manuals