LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1622 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Track - With Seat Integrated Restraints (SIR) >> Installation

Seat Track - With Seat Integrated Restraints (SIR): Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    Manual seats 

  1. Place the seat tracks on the seat pedestal frame and install the 7 screws (4 outboard side, 3 inboard side).
    • To install, tighten to 35 Nm (26 lb-ft).
      Fig 1: Locating Seat Adjuster Track Screws
      G04646077Courtesy of FORD MOTOR CO.
  2. Attach the fore/aft adjuster bar and install new pushclips on each side. Attach the seat assist spring.
    Fig 2: Locating Manual Fore/Aft Adjuster Bar Pushclips
    G04646078Courtesy of FORD MOTOR CO.

    3. Power seats 

  3. Connect the seat actuator motor electrical connector.
    Fig 3: Locating Seat Actuator Motor Electrical Connector
    G04646079Courtesy of FORD MOTOR CO.

    4. All seats 

  4. Install the front seat backrest. For additional information, refer to SEAT BACKREST - FRONT, WITH SEAT INTEGRATED RESTRAINTS (SIR) .
  5. Install the front seat cushion. For additional information, refer to SEAT CUSHION - FRONT, WITH SEAT INTEGRATED RESTRAINTS (SIR) .

    6. Power seats 

  6. Connect the seat control electrical connector.
    Fig 4: Locating Seat Control Electrical Connector
    G04646080Courtesy of FORD MOTOR CO.

    7. Heated seats 

  7. Connect the heated seat switch electrical connector.
    Fig 5: Locating Heated Seat Switch Electrical Connector
    G03911415Courtesy of FORD MOTOR CO.

    8. All seats 

    CAUTION: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.
  8. Position the side trim cover and install the 3 trim cover screws.
    • The seat backrest pivot bolt shaft must be inserted into the cover standoff.
      Fig 6: Locating Seat Backrest Pivot Bolt Shaft And Cover
      G03925447Courtesy of FORD MOTOR CO.
  9. Push the rearward lower corner of the side shield to engage the metal retaining clip.
  10. Position the lumbar adjuster control and install the 2 mounting screws.
    • Install the adjuster knob.
      Fig 7: Locating Mounting Screws
      G04646083Courtesy of FORD MOTOR CO.
  11. Position the seat back recliner lever cover and install the screw.
    Fig 8: Locating Seat Back Recliner Lever Cover And Screw
    G04646084Courtesy of FORD MOTOR CO.
  12. Install the front seat. For additional information, refer to SEAT - FRONT, WITH SEAT INTEGRATED RESTRAINTS (SIR) .
scientia non olet · About LEMON Manuals