Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: 40 percent seat shown, 60 percent seat similar.

Remove the seat. For additional information, refer to SEAT - REAR, SUPERCAB .
Remove the bolts.
1. Remove the upper bolt.
  - To install, tighten to 33 Nm (24 lb-ft).
2. Remove the lower bolt.
  - To install, tighten to 25 Nm (18 lb-ft).
    
    Fig 1: Locating Upper And Lower Bolt
    Courtesy of FORD MOTOR CO.
Remove the bolt and remove latch shield.
- To install, tighten to 50 Nm (37 lb-ft).
  
  Fig 2: Locating Latch Shield Bolt
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.