LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1622 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Backrest - Rear, Bench, CrewCab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat. For additional information, refer to SEAT - REAR, BENCH, CREWCAB .
  2. Separate the seat cover J-clip.
    Fig 1: Separating Seat Cover J-Clip
    G04646063Courtesy of FORD MOTOR CO.
  3. Pull the seat covering to access the seat back retaining bolts.
    Fig 2: Pulling Seat Covering
    G04646064Courtesy of FORD MOTOR CO.
  4. Remove the seat back bolts.
    • To install, tighten to 50 Nm (37 lb-ft).
      Fig 3: Locating Seat Back Bolts
      G04646065Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals