LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1622 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Armrest - Bucket, With Seat Integrated Restraints (SIR) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the affected seat. For additional information, refer to SEAT - FRONT, WITH SEAT INTEGRATED RESTRAINTS (SIR) .
  2. Remove the armrest.
    1. Release the armrest fabric from the pivot end of the armrest.
      2. NOTE: SIR seat has slide spacer on end of bolt.
    2. Remove the attachment bolt.
      • To install, tighten to 35 Nm (26 lb-ft).
    3. Pull the armrest from seat backrest.
      Fig 1: Identifying Seat Backrest
      G04646029Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals