LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1622 (Seat System -- F250-F550 Super Duty) >> Disassembly And Assembly >> Seat Cushion - Rear, Bucket, CrewCab >> Disassembly and Assembly

Disassembly and Assembly

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat quad bucket backrest. For additional information, refer to SEAT BACKREST - REAR, BUCKET, CREWCAB .
  2. Release the J-clips.
    Fig 1: Releasing J-Clips
    G04646140Courtesy of FORD MOTOR CO.
  3. Remove the 2 pin-type retainers.
    Fig 2: Locating Pin-Type Retainers
    G04646141Courtesy of FORD MOTOR CO.
  4. Remove the seat cushion pan from the cushion trim cover and foam pad assembly.
    Fig 3: Locating Seat Cushion Pan
    G04646142Courtesy of FORD MOTOR CO.
  5. Invert the seat cushion trim cover and remove all the hog rings and remove the trim cover from the cushion foam pad.
    Fig 4: Locating Trim Cover From Cushion Foam Pad
    G04646143Courtesy of FORD MOTOR CO.
  6. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals