LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1622 (Seat System -- F250-F550 Super Duty) >> Disassembly And Assembly >> Seat Cushion - Rear, 60/40, CrewCab >> Disassembly and Assembly

Disassembly and Assembly

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: 60 percent seat shown, 40 percent seat similar.
  1. Remove the 60 percent or 40 percent cushion. For additional information, refer to SEAT CUSHION - REAR, 60/40, CREWCAB .
  2. Using a suitable tool, remove the grocery bag hooks (if equipped).
    Fig 1: Locating Grocery Bag Hooks
    G04646149Courtesy of FORD MOTOR CO.
  3. Release the cushion trim cover J-clip.
    4. CAUTION: Use care when separating the cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the cushion foam.
  4. Release the 2 cushion trim cover side hook-and-loop strips.
  5. Invert the seat cushion trim cover and release the hook-and-loop strips.
  6. Remove the hog rings.
  7. Remove the cushion trim cover from the cushion foam pad.
  8. Remove the cushion foam pad from the cushion frame.
  9. To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals