Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the cowl top vent panels. For additional information, refer to FRONT END BODY PANELS .
Remove the wiper mounting arm and pivot shaft assembly.
1. Remove the 5 bolts.
  - To install, tighten to 11 Nm (8 lb-ft).
2. Disconnect the electrical connector.
3. Remove the wiper mounting arm and pivot shaft assembly.
  
  Fig 1: Identifying Wiper Mounting Arm And Pivot Shaft Assembly Electrical Connector
  Courtesy of FORD MOTOR CO.
Remove the bolt and the windshield wiper linkage.

Fig 2: Locating Windshield Wiper Linkage Bolt
Courtesy of FORD MOTOR CO.
Remove the bolts and the windshield wiper motor.

Fig 3: Locating Windshield Wiper Motor Bolts
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.