LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1621 (Wiper System & Washer System -- F250-F550 Super Duty) >> Removal And Installation >> Washer Pump and Reservoir >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Position windshield washer fluid reservoir aside.
    1. Remove the bolts.
    2. Position windshield washer fluid reservoir aside.
      Fig 1: Identifying Windshield Washer Fluid Reservoir And Bolts
      G04646521Courtesy of FORD MOTOR CO.
  3. Remove windshield washer fluid reservoir.
    1. Disconnect the electrical connector.
      2. WARNING: Windshield washer solution contains methanol which is poisonous. Observe all cautions and warnings indicated on label of washer solution container.
      NOTE: Windshield washer fluid should be collected in a container after the windshield washer hose is disconnected.
    2. Disconnect the windshield washer hose. (If equipped, disconnect the rear window washer hose.)
    3. Remove the windshield washer fluid reservoir.
      Fig 2: Identifying Windshield Washer Fluid Reservoir, Hose And Electrical Connector
      G04646522Courtesy of FORD MOTOR CO.
    4. Remove the windshield washer pump.
      Fig 3: Identifying Windshield Washer Pump
      G04646523Courtesy of FORD MOTOR CO.
      5. CAUTION: Do not make electrical connection prior to filling the windshield washer reservoir. Do not operate the windshield washer pump prior to filling the windshield washer reservoir.
    5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals