Removal and Installation
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the running board.
- Remove the bolts.
- To install, tighten to 23 Nm (17 lb-ft).
- Remove the running board.
- Remove the bolts.
- To install, reverse the removal procedure.
NOTE:
Left side Super Cab shown, regular cab, Crew Cab and tube running board similar. Right side symmetrically opposite.
NOTE:
Make sure to disconnect the running board lights electrical connector, if equipped.