LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1618 (Warning System -- F250-F550 Super Duty) >> Removal And Installation >> Key-In-Ignition Warning Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition lock cylinder. For additional information, refer to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
  2. Remove the key-in-ignition warning switch.
    1. Pry the clip downward.
    2. Release the key-in-ignition warning switch from the rear of the ignition lock cylinder.
      Fig 1: Identifying Key-In-Ignition Warning Switch
      G04645401Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals