Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these instructions could increase the risk of injury in collisions.

Remove the cap from the safety belt buckle nut.

Fig 1: Locating Safety Belt Buckle Nut
Courtesy of FORD MOTOR CO.
Remove the nut and the safety belt buckle.
- To install, tighten to 55 Nm (41 lb-ft).
  
  Fig 2: Locating Safety Belt Buckle Nut
  Courtesy of FORD MOTOR CO.
Remove the cap from the safety belt nut.
Remove the nut and the safety belt tongue.
- To install, tighten to 55 Nm (41 lb-ft).
  
  Fig 3: Locating Cap From Safety Belt Nut
  Courtesy of FORD MOTOR CO.

NOTE: Make sure the safety belt webbing is not twisted prior to installation.

NOTE: Make sure the safety belt is positioned in the retaining straps.

To install, reverse the removal procedure.
Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .