Antenna Lead-in Cable: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the antenna base. For additional information, refer to ANTENNA BASE .
Position the RH front fender splash shield away from the bulkhead.
1. Remove the 2 nuts.
2. Remove the screws.
3. Remove the pin-type retainers.
4. Position the RH front fender splash shield away from the bulkhead.
  
  Fig 1: Locating RH Front Fender Splash Shield
  Courtesy of FORD MOTOR CO.
Remove the pin-type retainer and the lower RH A-pillar trim panel.

Fig 2: Locating Pin-Type Retainer
Courtesy of FORD MOTOR CO.
Separate the antenna lead-in cable grommet from the bulkhead and pull the excess cable into the passenger compartment.

Fig 3: Identifying Antenna Cable Grommet
Courtesy of FORD MOTOR CO.
Remove the audio unit. For additional information, refer to AUDIO UNIT .

NOTE: This vehicle uses an antenna lead-in cable that is attached to the instrument panel reinforcement and the defroster air duct. Do not remove the original antenna lead-in cable from the vehicle.

Cut and remove the original antenna lead-in cable connectors and excess cable. Secure the remaining cable ends to avoid rattles or identification problems.