Antenna Lead-in Cable: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Route the new antenna lead-in cable into the passenger compartment.
- Make sure the grommet is fully seated.
  
  Fig 1: Identifying Antenna Cable Grommet
  Courtesy of FORD MOTOR CO.
Route and secure the new antenna lead-in cable to the instrument panel reinforcement.
Install the audio unit. For additional information, refer to AUDIO UNIT .
Install the pin-type retainer and the lower RH A-pillar trim panel.

Fig 2: Locating Pin-Type Retainer
Courtesy of FORD MOTOR CO.
Route the antenna cable through the antenna base opening on the cowl.
Position the RH front fender splash shield to the bulkhead.
1. Install the 2 nuts.
2. Install the screws.
3. Install the pin-type retainers.
  
  Fig 3: Identifying RH Front Fender Splash Shield
  Courtesy of FORD MOTOR CO.
Install the antenna base. For additional information, refer to ANTENNA BASE .