LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1600 (Engine Emission Control System - F250-F550 Super Duty 6.0L (99P F450/550)) >> Removal And Installation >> Positive Crankcase Ventilation (PCV) Heater Element - 5.4L >> Installation

Positive Crankcase Ventilation (PCV) Heater Element - 5.4L: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
  1. Using a new O-ring seal, install the PCV heater element and the bolt.
    • Tighten to 10 Nm (89 lb-in).
  2. Position the PCV tube and connect the quick connect couplings. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION - GASOLINE AND DIESEL .
  3. Connect the PCV heater element electrical connector.
  4. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
scientia non olet · About LEMON Manuals