LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine - 4.2L V6 - VIN 2) >> Removal & Installation >> Oil Pan >> Removal (4WD Pickup)

Removal (4WD Pickup)

WARNING: This page is about a different car, the 2001 Ford Pickup, 2001 Ford Econoline, 2000 Ford Pickup, and 2000 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
  1. With transmission in Neutral, raise and support vehicle. Mark front drive shaft and differential flange for installation reference. Disconnect front drive shaft from differential and support drive shaft. Disconnect front halfshafts from differential, and support aside.
  2. Disconnect vacuum lines from front axle tube. Using Hi-Lift Jack (014-00210) support front differential. Remove front differential support. Remove front differential bolts. Lower front differential, and position aside. Remove oil pan retaining bolts in reverse sequence. See Figure. Remove oil pan and gasket.
scientia non olet · About LEMON Manuals