LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine - 4.2L V6 - VIN 2) >> Removal & Installation >> Camshaft Synchronizer >> Installation

Camshaft Synchronizer: Installation

WARNING: This page is about a different car, the 2001 Ford Pickup, 2001 Ford Econoline, 2000 Ford Pickup, and 2000 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure crankshaft is still at TDC No. 1 compression stroke. Install synchro positioning tool on camshaft synchronizer by rotating tool until it engages notch in camshaft synchronizer housing.
    NOTE: During installation, arrow on synchro positioning tool will rotate clockwise as gears engage.
  2. Install camshaft synchronizer so arrow on synchro positioning tool is 54 degrees from centerline of engine. See Fig 1. Install camshaft synchronizer retaining bolt.
  3. Remove synchro positioning tool. Install camshaft position senor. To complete installation, reverse removal procedure. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS .
Fig 1: Aligning Camshaft Synchronizer
G97F03652Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals