LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1599 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Hood Latch Release Handle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the A-pillar lower trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the 3 parking brake control nuts.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Position the parking brake control aside.
  4. Remove the E-clip, release the return spring and position the hood latch release handle aside.
  5. Release the hood latch release cable and remove the hood latch release handle.
  6. To install, reverse the removal procedure.


  1. Remove the A-pillar lower trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the 3 parking brake control nuts.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Position the parking brake control aside.
  4. Remove the E-clip, release the return spring and position the hood latch release handle aside.
  5. Release the hood latch release cable and remove the hood latch release handle.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals