LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1599 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Door Latch Remote Control - SuperCab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear speaker. For additional information refer to INFORMATION AND ENTERTAINMENT SYSTEM .
  2. Position the watershield aside.
  3. Remove 3 upper rear door latch screws.
    • To install, tighten to 12 Nm (9 lb-ft).
  4. Remove 3 lower rear door latch screws.
    • To install, tighten to 12 Nm (9 lb-ft).
    5. CAUTION: When drilling out the latch remote control rivets, do not oversize the holes in the door sheet metal. Make sure not to exceed a 6.35 mm (0.25 in) drill bit.
  5. Remove the rear door latch remote control.
    1. Disconnect the actuating rods.
    2. Remove the rivets.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals