LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (MULTIFUNCTION Electronic Modules -- F250-F550 Super Duty) >> Removal And Installation >> Upfitter Relay Box >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upfitter switch assembly. For additional information, refer to UPFITTER SWITCH .
  2. Releasing the glove compartment stops, lower the glove compartment.
  3. Remove the 2 screws and position the upfitter relay box aside.
  4. Release the 2 tabs and remove the upfitter relay box from the bracket.
  5. Remove the ground bolt.
  6. Release the wiring harness locators and remove the upfitter relay box and harness assembly from the instrument panel.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals