Removal and Installation
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery. For additional information, refer to BATTERY DISCONNECT .
- Remove the screw and position the battery ground cable terminal aside.
- To install, tighten to 10 Nm (89 lb-in).
- Remove the bolt and position the battery cable harness bracket aside.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the nut and position the battery ground cable terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).
- Remove the stud nut and position the battery ground cable eyelet aside.
- To install, tighten to 40 Nm (30 lb-ft).
- Remove the nut and position the starter solenoid wire terminal aside.
- To install, tighten to 5 Nm (44 lb-in).
- Remove the nut and position the starter solenoid positive cable terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).
- Remove the nut and position the generator B+ cable terminal and the CJB cable terminal aside.
- To install, tighten to 8 Nm (71 lb-in).
- Disconnect the starter relay electrical connector.
- Remove the battery cable assembly.
- To install, reverse the removal procedure.