LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1586 (Instrument Cluster System) >> Removal And Installation >> Instrument Cluster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Prior to removal of the instrument cluster, it is necessary to upload the instrument cluster configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION .
  1. Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
  2. Remove the instrument cluster finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  3. Lower the steering wheel tilt adjustment to the lowest position.
  4. Remove the 4 screws and position the instrument cluster away from the instrument panel.
    • Disconnect the electrical connectors.
  5. If equipped with column shift, push in the 2 clips and disconnect the transmission range indicator.
  6. To install, reverse the removal procedure.
    • Download the instrument cluster configuration information from the scan tool to the new instrument cluster. For additional information, refer to MODULE CONFIGURATION .
scientia non olet · About LEMON Manuals