LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1585 (Anti-Lock Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Speed Sensor - Front, Rear Wheel Drive (RWD) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the front wheel speed sensor electrical connector.
  3. Remove the wheel speed sensor harness retainer and separate the harness from the routing clips.
  4. Remove the bolt and the front wheel speed sensor.
    • To install, tighten to 18 Nm (13 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals