LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1585 (Anti-Lock Brake System -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Speed Sensor - Front, Four Wheel Drive (4WD) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front disc brake rotor shield. For additional information, refer to FRONT DISC BRAKE .
  2. Disconnect the front wheel speed sensor electrical connector.
  3. Remove the 4 wheel speed sensor harness retainers.
    CAUTION: Make sure the ABS harness is properly routed to prevent the disc from cutting the ABS harness.
  4. Remove the screw and the front wheel speed sensor.
    • To install, tighten to 18 Nm (13 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals