LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1585 (Anti-Lock Brake System -- F250-F550 Super Duty) >> Diagnosis And Testing >> Anti-Lock Control >> Pinpoint Tests >> Pinpoint Test C: DTCs C1095 and C1096 >> Code Description

Code Description

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

ABS Hydraulic Pump Motor Circuit Failure/Open

Anti-lock brake system (ABS) diagnostic trouble code (DTC) C1095 sets only when the motor is initially commanded on for 100 ms (+1-6 ms), and the ABS hydraulic pump motor is then commanded off and the voltage back is read after 6 ms. If the voltage indicates the motor is spinning at less than 500 RPM, there may be a locked motor. If this condition is detected 4 times, a locked motor DTC C1095 is set. The pump motor is checked for an open circuit 2 seconds after the most recent successful pump motor off command. If the pump motor feedback remains greater than 0.75 volt for more than 50 ms (+1-6 ms) after these conditions have been met, DTC C1096 is set.

Voltage is supplied from the battery junction box (BJB) through circuit 532 (OG/YE) (voltage at all times). Ground is provided through circuit 530 (LG/YE).

scientia non olet · About LEMON Manuals