LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1584 (Hydraulic Brake System Actuation -- F250-F550 Super Duty) >> Removal And Installation >> Brake Master Cylinder >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Disconnect the fluid level sensor connector.
  2. If equipped, disconnect the brake pressure switch and the trailer brake control transducer electrical connectors.
  3. Disconnect the brake tube-to-master cylinder fittings.
    • To install, tighten to 18 Nm (13 lb-ft).

    4. Vehicles with vacuum booster 

  4. Remove the brake master cylinder nuts and the brake master cylinder.
    • To install, tighten to 27 Nm (20 lb-ft).

    5. Vehicles with Hydro-Boost® 

  5. Remove the power steering tube bracket nuts and position the bracket aside.
    • To install, tighten to 27 Nm (20 lb-ft).
  6. Remove the brake master cylinder.

    7. All vehicles 

  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals