LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (Automatic Transmission External Controls - F250-F550 Super Duty) >> General Procedures >> Selector Lever Indicator Adjustment

Selector Lever Indicator Adjustment

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper instrument panel steering column cover.
  2. Place the selector lever in the (D) position.
    • Rotate the selector lever clockwise until it bottoms out (1ST gear). Rotate the lever 3 detents counterclockwise (D) for the TorqShift transmission.
  3. Center the pointer in the middle of the (D) position.
    • Rotate the thumbwheel located on the bottom of the steering column to adjust the pointer.
      Fig 1: Locating Steering Column Pointer
      G04650266Courtesy of FORD MOTOR CO.
  4. Carefully move the selector lever from detent to detent and compare with transmission settings. Readjust if necessary.
  5. Install the upper instrument panel steering column cover.
scientia non olet · About LEMON Manuals