General Specifications
WARNING: This page is about a different car, the 2006 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Lubricants and Sealants | |
| Threadlock and Sealer E0AZ-19554-AA | WSK-M2G351-A5 (Type II) |
| Threadlock 262 E2FZ-19544-B | WSK-M2G351-A6 |
| Silicone Lubricant F7AZ-19G208-BA | ESR-M13P4-A |
| Gasket and Trim Adhesive F3AZ-19B508-AA | - |
| Gasket Maker F8AZ-19B508-AB | WSK-M2G348-A5 |
| Preload | |
| Mainshaft and countershaft | 0.02-0.09 mm (0.00079-0.0035 in) |
| Component Mounting Temperatures | |
| Taper roller bearing inner race | 150°C (300°F) |
| Synchronizer assemblies | 150°C (300°F) |
| Thrust washers | 150°C (300°F) |
| Shaft bushings | 150°C (300°F) |
| Top roller bearing outer race | 150°C (300°F) |
| Output ball bearing | 150°C (300°F) |
| Fluid | |
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1 (Canada CPM-1) | ESA-M6C25-A |
| MERCON® Multi-Purpose Automatic Transmission Fluid XT-2-QDX (US); XT-2-LM12 (Canada) | MERCON® |
| Fluid Capacity | |
| Transmission w/o oil cooler | 5.5L (5.81 qt) |
| Transmission oil cooler | 0.5L (0.53 qt) |
| Synchronizer | |
| 1st and 2nd synchronizer with new gear and synchronizer ring clearance | 1.5-1.85 mm (0.059-0.073 in) |
| 3rd, 4th, 5th, reverse and low with new gear and synchronizer ring clearance | 1.4-1.7 mm (0.055-0.066 in) |
| 1st and 2nd service limit | 1.0 mm (0.04 in) |
| 3rd, 4th, 5th, reverse and low service limit | 1.0 mm (0.04 in) |