Power Steering Pump Pulley: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed 2 times.

Fig 1: Identifying Special Tool - 211-185 On Pulley

Courtesy of FORD MOTOR CO.

Using the special tool, install the power steering pump pulley.

NOTE: Vehicle with air conditioning shown, vehicle without air conditioning similar.

Rotate the accessory drive belt tensioner and install the accessory drive belt on the power steering pump pulley.
- For vehicles with air conditioning, rotate the tensioner clockwise.
- For vehicles without air conditioning, rotate the tensioner counterclockwise.
  
  Fig 2: Rotating Drive Belt Tensioner Clockwise
  Courtesy of FORD MOTOR CO.

Vehicles with 6.0L engine

Install the engine cooling fan. For additional information, refer to ENGINE COOLING .