Removal and Installation
WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power steering components can result.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Loosen the 2 clamps and disconnect the 2 fluid cooler return hoses.
- To install, tighten to 3 Nm (27 lb-in).
- Remove the 2 bolts and the power steering fluid cooler.
- To install, tighten to 11 Nm (8 lb-ft).
- To install, reverse the removal procedure.
- Fill the power steering system. For additional information, refer to STEERING SYSTEM-GENERAL INFORMATION .