LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Automatic Transmission - F250-F550 Super Duty) >> In-Vehicle Repair >> Transmission Support CROSSMEMBER >> Removal

Transmission Support CROSSMEMBER: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Install a suitable high-lift transmission jack.
  3. Remove the wire harness from the rear crossmember.
    Fig 1: Locating Wire Harness At Rear Of Crossmember
    G03908863Courtesy of FORD MOTOR CO.
  4. Remove the rear transmission insulator nuts.
    Fig 2: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  5. Remove the LH crossmember bolts and nuts.
    1. Loosen, but do not remove, the bolt and nut indicated.
      Fig 3: Locating LH Crossmember Bolts
      G04649734Courtesy of FORD MOTOR CO.
  6. Remove the RH crossmember bracket bolts and nuts.
    1. Remove the bracket bolts and nuts.
    2. Remove the bracket.
      Fig 4: Locating RH Crossmember Bracket Bolts
      G04649735Courtesy of FORD MOTOR CO.
  7. Remove the RH crossmember bolts and nuts.
    Fig 5: Identifying RH Crossmember Bolts And Nuts
    G03920816Courtesy of FORD MOTOR CO.
  8. Remove the LH crossmember bolt, nut and the crossmember.
    1. Remove the bolt and nut
    2. Remove the crossmember.
      Fig 6: Locating LH Crossmember Bolt
      G04649737Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals