LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Automatic Transmission - F250-F550 Super Duty) >> In-Vehicle Repair >> Extension Housing Seal >> Installation

Extension Housing Seal: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    Vehicles without a fixed flange 

  1. Using the special tool, install the extension housing seal.
    Fig 1: Identifying Extension Housing Seal
    G04649632Courtesy of FORD MOTOR CO.

    2. Vehicles with a fixed flange 

  2. Using the special tool, install the output shaft seal.
    Fig 2: Identifying Output Shaft Seal
    G04649633Courtesy of FORD MOTOR CO.
  3. Using the special tool, install a new output shaft nut.
    • Tighten to 200 Nm (148 lb-ft).
      Fig 3: Identifying Output Shaft With Special Tool
      G04649634Courtesy of FORD MOTOR CO.
  4. Install the output shaft flange and a new bolt.
    • Tighten to 130 Nm (96 lb-ft).
      Fig 4: Locating Output Shaft Flange Bolt
      G04649635Courtesy of FORD MOTOR CO.

    5. 4WD vehicles 

  5. Install the transfer case. For additional information, refer to TRANSFER CASE .

    6. All vehicles 

  6. Install the driveshaft. For additional information, refer to DRIVESHAFT .
scientia non olet · About LEMON Manuals