LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Automatic Transmission - F250-F550 Super Duty) >> In-Vehicle Repair >> Extension Housing Gasket - Rear Wheel Drive (RWD) >> Removal

Extension Housing Gasket - Rear Wheel Drive (RWD): Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT .

    2. Vehicles equipped with a fixed flange 

  2. Remove the output shaft flange.
    1. Remove and discard the output shaft flange bolt.
    2. Remove the output shaft flange.
      Fig 1: Identifying Output Shaft Flange And Bolt
      G04615854Courtesy of FORD MOTOR CO.

    3. All vehicles 

  3. Remove the transmission rear crossmember support insulator nuts.
    Fig 2: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  4. Install a suitable transmission jack.
  5. Remove the transmission rear crossmember support insulator bolts.
    Fig 3: Identifying Transmission Support Insulator Bolts
    G03889100Courtesy of FORD MOTOR CO.
  6. Raise the transmission upward, off the rear transmission mount and remove the rear transmission mount.
    Fig 4: Locating Rear Transmission Mount
    G04649640Courtesy of FORD MOTOR CO.
  7. Disconnect the output shaft speed (OSS) sensor electrical connector.
    Fig 5: Identifying Output Shaft Speed (OSS) Sensor Electrical Connector
    G03889074Courtesy of FORD MOTOR CO.

    8. Vehicles equipped with a fixed flange 

  8. Using the special tool, remove the output shaft retaining nut.
    Fig 6: Identifying Output Shaft With Special Tool
    G04649634Courtesy of FORD MOTOR CO.
  9. Remove the bolts and the transmission extension housing.
    Fig 7: Locating Transmission Extension Housing Bolts
    G03889104Courtesy of FORD MOTOR CO.

    10. Vehicles not equipped with a fixed flange 

  10. Remove the bolts and the transmission extension housing.
    Fig 8: Locating Transmission Extension Housing Bolt
    G04649644Courtesy of FORD MOTOR CO.

    11. All vehicles 

  11. Remove and discard the extension housing gasket.
    Fig 9: Locating Extension Housing Gasket
    G03889106Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals