LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1560 (Engine - 6.0L (99P F450/550) Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Install the gears with marks pointing outward.
    Fig 1: Identifying Inner And Outer Oil Pump Drive Rotors With Alignment Marks
    G03887281Courtesy of FORD MOTOR CO.
  1. Lubricate the inner gear with lithium assembly grease and install onto the crankshaft. Lubricate the outer gear with lithium assembly grease and mesh with the inner gear rotor in the oil pump housing. Wipe off the excess assembly grease.
    2. NOTE: Install a new O-ring seal.
  2. Install the gerotor cover and bolts.
    • Tighten to 13 Nm (10 lb-ft).
      Fig 2: Locating Oil Pump Body Bolts
      G03887280Courtesy of FORD MOTOR CO.
  3. Install the crankshaft front seal. For additional information, refer to CRANKSHAFT FRONT SEAL .
scientia non olet · About LEMON Manuals