LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1559 (Engine - 6.8L (3V) -- F250-F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the flexplate or flywheel. For additional information, refer to FLEXPLATE  or FLYWHEEL .
  2. Remove the engine rear cover plate.
  3. Using the special tools, remove and discard the crankshaft oil slinger.
    Fig 1: Removing Crankshaft Rear Oil Seal Slinger
    G03920149Courtesy of FORD MOTOR CO.
  4. Using the special tools, remove and discard the crankshaft rear seal.
    Fig 2: Removing Crankshaft Rear Seal
    G03920150Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals