Camshaft Roller Follower: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

All camshaft roller followers

CAUTION: If the components are to be reinstalled, they must be installed in the same positions or engine damage may occur. Mark the components for installation into their original locations.

NOTE: Lubricate the camshaft roller followers with clean engine oil prior to installation.

Fig 1: Identifying Special Tool For Removing/Installing Camshaft Roller Followers

Courtesy of FORD MOTOR CO.

Using the special tool, compress the valve spring and install the camshaft roller follower.
Repeat the previous step for each camshaft roller follower being serviced.

Cylinder No. 7 front intake valve roller follower

Position the camshaft bearing cap and install the 2 bolts in 2 stages:
- Stage 1: Tighten to 8 Nm (71 lb-in).
- Stage 2: Tighten an additional 45 degrees.
  
  Fig 2: Identifying Bolts And Camshaft Bearing Cap
  Courtesy of FORD MOTOR CO.

Cylinder No. 10 front intake valve roller follower

Position the camshaft bearing cap and install the 2 bolts in 2 stages:
- Stage 1: Tighten to 8 Nm (71 lb-in).
- Stage 2: Tighten an additional 45 degrees.
  
  Fig 3: Identifying Bolts And Camshaft Bearing Cap
  Courtesy of FORD MOTOR CO.

All camshaft roller followers

Depending on the valve being serviced, install the LH or RH valve cover. For additional information, refer to VALVE COVER - LH or VALVE COVER - RH .