LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1558 (Engine - 5.4L (3V) - F250 & F350) >> In-Vehicle Repair >> Valve Cover - LH >> Installation

Valve Cover - LH: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If the valve cover is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure can cause future oil leakage.
    Fig 1: Applying Bead Of Silicone Gasket And Sealant In 2 Places Where Engine Front Cover Meets Cylinder Head
    G03919870Courtesy of FORD MOTOR CO.
  1. Apply a bead of silicone gasket and sealant in 2 places where the engine front cover meets the cylinder head.
  2. Position the LH valve cover and a new gasket on the cylinder head and tighten the bolts in the sequence shown.
    • Tighten to 10 Nm (89 lb-in).
      Fig 2: Identifying Tighten Sequence Of Valve Cover Bolts
      G03919871Courtesy of FORD MOTOR CO.
  3. Position the intake manifold vacuum tube assembly onto the support bracket and the valve cover stud.
  4. Connect the VCT solenoid electrical connector and the wiring harness retainers.
  5. Connect the radio ignition interference capacitor electrical connector.
  6. Position the PCV tube and connect the quick connect couplings. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION - GASOLINE AND DIESEL .
  7. Connect the intake manifold vacuum tube hose to the brake booster.
  8. Install the oil level indicator and tube. For additional information, refer to OIL LEVEL INDICATOR AND TUBE .
  9. Install the LH ignition coils. For additional information, refer to ENGINE IGNITION - 5.4L AND 6.8L (3V) .
  10. Install the air cleaner intake pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
scientia non olet · About LEMON Manuals